10-00640 REV A
4
6 CONNECTOR WIRING/CONFIGURATIONS
NOTE: For
DC Units
4 Pins are required for RS-485 Lamps and 3 Pins are required for
Analog Control Lamps.
NOTE: For
AC Units
5 Pins are required for RS-485 and Analog Control Lamps
CAUTION: Do not apply power to RS-485 pins as it will damage the
RS-485 driver electronics.
24 VDC
120 VAC
RS485 (Except -04
Configuration)
Analog
0-5 or 0-10VDC
RS485 (-04
Configuration)
None
(Full on)
RS485
Analog
0-5 or 0-10VDC
Full on or
Phase
Control
1 - DC Common
1 - DC Common
1 - +26VDC
1 - DC Common 1 - Ground
1 - Ground
1 - Ground
2 - +24 VDC
2 - +24 VDC
2 - 26VDC RET
2 - +24 VDC
2 - Load
2 - Load
2 - Load
3 - RS 485 A
3 - Analog Dimming Input
3 - GND
3 - Neutral
3 - Neutral
3 - Neutral
4 - RS-485 B
4 - N/C
4 - RS 485 A
4 - DC Common
5 - RS485-B
5 - RS-485 B
5 - Analog Dimming Input
6 - RS485-A
7 - N/C
Note:
If a connector has more pins than is listed in the table above, all other pins that are not listed are not
connected.
Example:
24 VDC, RS485 light with a 6 pin connector would be:
1 - DC Common, 2 - +24 VDC, 3 - RS485 A, 4 - RS485 B, 5 - Not Connected, 6 - Not Connected.
-01 MCBH-4-MP
SS SUBCONN
-02 LPMBH-4-MP
BRASS IMPULSE
-03 BH-4-MP
BRASS SUBCONN
-04 SEANET 101
SS SCHILLING
-07 5507-1503
SS SEACON
-09 LPBH-3-MP
BRASS
SUBCONN
-10 BH-3-MP
BRASS SUBCONN
-12 MSAJ-3-BCR
CRE SEACON
