Page 5
5.
Supply points, water supply and waste
Length of Aluminium bar = Length of worktop minus 5 cm
Length of Hex 6 shaft = Length of worktop minus 15 cm
It is advisable to place water supply and waste within the hatched area. Also it is important to use
flexible hoses for water supply and waste to ensure that the Flexi will move freely without obstacles
within the height adjustment range 65-95 cm. excl. worktop.
It is advisable to place the water supply and waste close to the sink. The drain may also be
installed in the floor.
Arrange for the fixed feed pipes on the wall to be pointing down, at a height of max. 30 cm.
This will ensure that the flexible feed pipes will always flex in a neat curve close to the wall
without kinking. A 90 degree valve with a 1/2" exposed thread is recommended.
The control unit complies with IP32/ll and must always be installed in accordance with the
national Heavy Current Regulations or corresponding international or national standards.
The cables to the control unit must be able to move freely during height adjustment of the Flexi.
For worktops with cut-outs the distance from either side of the worktop should be considered as
shown on the illustration.
Length of the worktop
8
Length of the worktop
Always keep 0,5
cm space all away
around the
worktop
