Page | 11
TF 200.01.0014_eng
4.1.9
Lock the system by securing the retainer
nut at the bottom of each motor column
4.1.10
Mount support arms on profile evenly
distributed and place angled bracket on
the innermost support arms
At each motor column, a support arm should
be placed on top of the adjustment screw.
Do note, that the inner support arms must not
be more than 60cm (23.5in) apart. Also note
that the outermost support arms must face
inwards with their outer bracket. This is done
by unscrewing the bracket.
Mount the angled bracket in the suggested
order.
Fasten it with two M6x12 buttonhead screws.
4.1.11
Mount the control box by tightening the
screws
Make sure that all the cables can reach the
control box, and that it is placed close to a
power outlet.
For large frames (greater than 220cm (86.5in)
per side), an extension cable should be
connected to the outer leg(s).
1
3
2
