Ropex RESISTRON RES-5009, User Manual, Page: 46 / 98

Device functions
Page 46 RES-5009 Version 1
With the ROPEX visualisation software ROPEXvisual
®
the following may happen
• error messages may be read out
• Temperature curves may be recorded
• Status bits may be displayed
• Parameters may be set
• manual triggering of welding pulses can be generated during startup
The ROPEX-Visualisation software ROPEXvisual
®
is intended for startup and the error diagnosis. Permanent
records of the sealing parameters cannot be created with this. The recording of the sealing parameters or status
bits must be done within the machine control. A separate document is available for the ROPEX-visualisation soft-
ware ROPEXvisual
®
.
The software and the documentation are available in the download area (search term: “Visual”).
9.9 AUX interface
Internal interface for diagnosis and maintenance. The interface is currently not available.
9.10 Total cycles counter
From the time of delivery of the RESISTRON
®
Temperature Controller RES-5009, the number of welding cycles
performed (ST bit = 1) is stored in the controller. This counter can only be displayed, but not reset. Display is pos-
sible with the ROPEX visualisation software (
 section 9.8 "USB interface for visualisation software ROPEX-
visual
®" on page 45
) or via the services of the CAN interface.
AU
X
0
5
1 2
3
4
6
78
9
SWIT CH P OS.
1
0
4
5
8
9
TEM P. RA NGE
300°C
300°C
500°C
500°C
300°C
PC CO NF IG URA TIO N
780ppm /K
1 100p pm /K
(L)
(A 20)
1 100p pm /K (A 20)
780ppm /K
3500ppm /K
(L)
TEM P. C OEFFI CIE NT
AU
X