2
Place the template over the anchor pins, selecting the appropriate
hole numbers (on the anchors) so that the 430mm dimension from
the front of the pan to the centre line of the template is met.
3
Once the 430mm dimension shown above is met and the template is
parallel to the back edge, insert the bolts then tighten using a screw
driver.
AFTERCARE INSTRUCTIONS
Removing seat for cleaning
For Technical Help Call:
01225 303 900
Roper Rhodes Ltd | Brassmill Lane Trading Estate | Bath | BA1 3JF
E: [email protected]
W: www.roperrhodes.co.uk
Secure as tightly
as possible by
hand. Do NOT
use a battery drill
or driver.
Note: Selected anchor numbers must be the same
BLEACH
CLEANER
CREAM
CLEANER
Clean surfaces with a soft
damp cloth and mild
soap solution
Do not scrub or scour
Do not use abrasive
cleaning agents.
Do not stand on the lid or
ring of your toilet seat
Do not use abrasive cleaning agents. If using bleach, abrasive
or corrosive cleaning agents inside the toilet bowl, ensure that
these do not come into contact with the seat. Keep the seat in
the upright position until all cleaner has been flushed away.
• The fittings pack contains small items which should be kept away from young
children.
• The toilet seat can be dangerous if incorrectly installed. Assembly should be carried
out by a competent person. No liability will be accepted for damage or injury caused
by incorrect product installation or assembly.
• Do not stand on the lid or ring of your toilet seat.
• After a few days check that the fixings are still tight. This is necessary as the rubber
components will compress during the first few days.
• Periodically check all fixings to ensure none have come loose and re-tighten where
necessary. Please take care when handling or moving the toilet seat as careless
handling may cause damage or injury.
• Never over rotate the seat open when it is removed from the WC as this can cause
damage to the hinges.
• Do not force down the seat ring or lid as this may compromise the performance of
the soft close hinges.
WARNINGS
Instructions B - Fitting on Alternative
Pan
Click seat in place.
5
4
Remeasure the distance, making sure the 430mm dimension is met
and remove the template and add the cover cap.
A
Select
appropriate
hole number
430mm
E
8901WSC-SF - v3 08.20