ENVY WALL MOUNTED UNIT EN700x, EN600x
FITTING INSTRUCTIONS
Please retain for future reference
ENVY 1200 WALLMOUNTED WASHSTAND
FITTING INSTRUCTIONS
Please retain for future reference
Before you start
It is recommended that the unit and basin are secured to a suitably reinforced wall to ensure stability. The wall plugs supplied are only suitable for solid stone /
brick walls. For plasterboard walls use specialist wall plugs along with supplementary wall strengthening as units can be very heavy. Seek advice from a special-
ist about the suitability of fixings to be used.
Wear suitable eye protection when drilling. Take care when using power tools near water - the use of a residual current device (RCD) is recommended. Beware
of hidden pipes or cables. Take care when drilling tiled surfaces as the drill might slip. Use a piece of masking tape to prevent the drill from wandering.
REF: RR.EN1200x | V2.00 07.11
Customer S ervices, Roper Rhodes Ltd, Brassmill Lane Trading E state, Bath, BA1 3JF
TEL: 01225 303 900
|
FAX: 01225 448 877
Email: [email protected]
|
Web: www.roperrhodes.co.uk
A B C
Door
Furniture Frame
Hinge adjustment
Hinges may require adjustment for both the doors to fit neatly together. This is achieved with the adjustable soft close hinges using the adjustment screws A
and B (see instructions below). To access these you may first have to remove the screw cap cover. The hinges also feature a quick release mechanism to
quickly and easily detach the door from the furniture frame.
Screw A offers left / right adjustment for levelling up the doors (Adjustment 1).
Screw B offers forward / back adjustment (Adjustment 2).
Button C is the quick release, press this on both hinges to remove a door by releasing the hinges from their mounting plates.
1
1
2
2
1
Mark the location of each of the wall mounting plates
ensuring that they are positioned inside the sidewalls
of the vanity unit. We recommend that the height of the
brackets be set such that the overall height incuding
the basin is 860mm. For each mounting plate drill two
holes in the marked positions using a 8mm drill bit to a
depth of 55mm.
2
Locate the hangers onto
the wall mounting plates.
Wall hangers not only
tighten the unit against the
wall (Screw A) but also
offer up/down adjustment
to fine-tune the fixing
position (Screw B).
Finally fold over flap C to
conceal the adjustment
screws on the wall hanger.
B
C
A
inside the unit walls
height
3
4
