MOUNTING INSTRUCTIONS
Installing the winch is easy, if you follow these instructions. The numbers in ( ) refer
to the item numbers in the parts list and exploded view diagram.
Tools required for the installation:
• Small flat screwdriver.
• Ø6.5 mm (1/4”) drill.
• Pencil / marker.
• Cleaning cloth.
• Bedding compound.
1. Remove circlip (1), using a small flat screwdriver.
2. Remove drum (2).
3. Place the winch in the desired location on the boat and mark location of the
bolt holes using the included template, or using winch base (8) as a template.
Note:
Do not drill through the winch base.
4. Remove the winch base.
5. Drill bolt holes Ø6.5mm (1/4”).
Make sure that no dust comes into contact with the winch while drilling.
6. Clean the area.
7. Apply a light coat of bedding compound, ensuring that each bolt hole will be sealed.
Keep area for drain groove in base clear.
8. Fasten the winch into place using 4 x Ø6mm (1/4”) countersunk head screws.
Use large washers or a backing plate, on the underdeck side.
9. Assemble in reverse order.
10. Check that the winch is functioning correctly:
- The drum should operate smoothly, when turning the drum clockwise by hand.
- The drum must not turn when trying to turn the drum anti clockwise by hand.
- While turning the winch handle clockwise the drum should turn.
- While turning the winch handle anti clockwise the drum should not turn.
• 4 x Ø6 mm (1/4”) countersunk head screws and
corresponding nuts (length to suit deck thickness).
• 4 x large washers or backing plate.
•
Mounting dimension template (included).
Pawl spring mounting
Note the orientation of
the bent spring “arm”
p4
Classic 10
(V.3.0)
