MOUNTING INSTRUCTIONS
PAWL SPRING MOUNTING
Installing the winch is easy, if you follow these instructions. The numbers in ( ) refer to the
position numbers in the parts list.
Tools required for the installation:
• Allen key (4 mm)
• Allen key (5 mm)
• Allen key (6 mm)
• Ø8.5 mm (11/32”) drill
• Bedding compound
1. Drill bolt holes Ø8,5mm (11/32”) using the winch template.
Be sure that no dust comes in contact with the winch, while drilling.
2. Remove screws (1).
3. Remove self-tailing arm (2) and drum (4).
4. Apply a light coat of bedding compound, ensuring that each bolt hole is bedded.
Keep drain grooves clear.
5. Fasten lower base (19) into place using 5 pcs. M8 (5/16”) bolts.
Use large washers or a backing plate.
6. Assemble in reverse order.
7. Check that the winch is functioning correctly:
- The drum should operate smoothly, when turning the drum clockwise by hand.
- The drum must not turn when trying to turn the drum anti clockwise by hand.
- While turning the winch handle clockwise the drum should turn slowly.
- While turning the winch handle anti clockwise the drum should turn quickly.
Note the curved
spring “arm”
• 5 x M8 (5/16”) screws and corresponding
nuts (length
depending on deck thickness)
• 5 x large washers or backing plate
• Ring spanner to match nuts
p4
46ST (V.5.0)
|
46ST FS (V.5.0.F)
50ST (V.2.0)
|
50ST FS (V.2.0.F)
