MOUNTING INSTRUCTIONS
PAWL SPRING MOUNTING
Installing the winch is easy, if you follow these instructions. The numbers in ( ) refer to the
position numbers in the parts list.
Tools required for the installation:
• Allen key (4 mm)
• Allen key (5 mm)
• Ø6.5 mm (1/4”) drill
• Bedding compound
1. Remove screws (1).
2. Remove self-tailing arm (2) and drum (4).
3. Mark location of boltholes using the template.
IMPORTANT:
On the 34ST the self-tailing arm (2) is fixed in one position.
Ensure correct positioning of the self-tailing arm, before marking the bolt holes.
Drill bolt holes Ø6.5mm (1/4”). Be sure that no dust comes into contact with the winch
while drilling.
5. Apply a light coat of bedding compound, ensuring that each bolthole is bedded.
Keep drain grooves clear.
6. Fasten base (15) into place using 5 pieces. M6 (1/4”) countersunk head screws.
Use large washers or a backing plate.
7. Assemble in reverse order.
8. Check that the winch is functioning correctly:
- The drum should operate smoothly, by turning the drum clockwise by hand.
- The drum must not turn when trying to turn the drum anti clockwise.
- While turning the winch handle clockwise the drum should turn.
- While turning the winch handle anti clockwise the drum should not turn.
Note the curved
spring “arm”
• 5 x M6 (1/4”) countersunk head screws and corresponding
nuts (length depending on deck thickness)
• 5 x large washers or backing plate
• Ring spanner to match nuts
p4
34ST
(V.2.0)
34ST FS
(V.2.0.F)