USER MANUAL
15
this product for extended work on these types of materials.
However, if you do work with any of these materials, it is extremely
important to clean the product using compressed air.
.
BEARING LUBRICATION
All of the bearings in this product are lubricated with a sufficient amount
of high grade lubricant for the life of the unit under normal operating
conditions. Therefore, no further lubrication is required.
.
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing of as waste. The machine,
accessories and packaging should be sorted for environmental-friendly
recycling.
.
TROUBLESHOOTING
PROBLM
CAUSE
POSSIBLE SOLUTION
Compressor will not
run
Loss of power or overheat-
ing
Check for proper use of extension cord
NO electrical power
Check to be sure unit is plugged in
Blown shop/house fuse
Check fuse/ breaker
Shop/house breaker open
Replace shop/house blow fuse
Current limiting protector
open
Reset shop/house breaker, determine
why problem happened
Pressure switch bad
Motor will restart when cool
Tank is full of air
Compressor will tum on when tank
Pressure drops to cut- in pressure
Motor hums but can-
not run or runs slowly
Low voltage
Check with voltmeter
Wrong gauge wire or length
of extension cord
Check for proper gauge wire and cord
length
Shorted or open motor
winding
Take compressor to service center
Defective check valve or
unloader
Take compressor to service center
Current limiting pro-
tector
Protector cuts out
repeatedly
LOW voltage
Check with voltmeter
Lack of proper ventilation/
room temperature too high
Move compressor to well- ventilated
area
Wrong gauge wire or length
of extension cord
Check for proper gauge wire and cord
length
