USER MANUAL
11
REVERSE (COUNTER CLOCKWISE) OPERATION:
The electronic clutch has two different reverse modes: Full Reverse and
Auto Break. The Full Reverse mode is automatically activated when
the direction switch (2) is put into the reverse position. No LEDs on the
Electronic clutch control panel should be illuminated. This means that
the clutch is set to full reverse mode. When the trigger is pushed the tool
will operate in reverse for as long as you hold down the trigger. The Auto
Break function is engaged by pushing the B button on the Electronic
clutch control panel (5). A red LED will illuminate in the third LED position
to indicate that the Auto Break is engaged. When the trigger is pushed
the tool will start hammering in reverse. As soon as the bolt breaks loose
and there is no resistance the tool will immediately stop reverse motion.
This feature is meant for controlled loosening of lug nuts without backing
fully off the stud. Uncontrolled spinning can damage the treads on the
end of the stud or bolt. To disengage break just push the B button one
more time and the red LED will turn off. Your tool is again in the full
reverse mode. NOTICE: Both reverse functions only operate with the
electronic clutch in the third speed position. This feature is unavailable
in speed one and two
MAINTENANCE
CAUTION:
-Always be sure that the tool is switched off and the battery cartridge is
removed before attempting to perform inspection or maintenance.
-Never use gasoline, benzene, thinner, alcohol or the like. Discoloration,
deformation or cracks may result.
NOTE:
To maintain product safety and reliability repairs, any other maintenance
or adjustment should be performed by
Ronix Service
Authorized Service
Centers, always using RONIX replacement parts.
