Ronde & Schwarz R&S FPL1000, User Manual

Page: 520 / 1076

General Instrument Setup
R&S
®
FPL1000
520 User Manual 1178.3370.02 ─ 09
Remote command:
*TST?
on page 617
DIAGnostic:SERVice:STESt:RESult?
on page 958
9.5.3 Calibration Signal Display
Access : [Setup] > "Service" > "Calibration Signal"
Alternatively to the RF input signal from the front panel connector you can use the
instrument's calibration signal as the input signal, for example to perform service func-
tions on.
NONE ..........................................................................................................................520
Calibration Frequency RF ........................................................................................... 520
└ Frequency ..................................................................................................... 520
NONE
Uses the current RF signal at the input, i.e. no calibration signal (default).
Remote command:
DIAGnostic:SERVice:INPut[:SELect]
on page 957
Calibration Frequency RF
Uses the internal calibration signal as the RF input signal.
Remote command:
DIAGnostic:SERVice:INPut[:SELect]
on page 957
DIAGnostic:SERVice:INPut:PULSed:CFRequency
on page 956
Frequency ← Calibration Frequency RF
Defines the frequency of the internal broadband calibration signal to be used for IF fil-
ter calibration (max. 64
MHz).
Service Functions