Ronde & Schwarz 1424.6721K02, User Manual

Page: 85 / 148

Remote control commands
R&S
®
NRP18S-xx
85 User Manual 1178.3686.02 ─ 07
User interface of the S-Parameters program
Figure 8-10: S-Parameters dialog
Menu bar ....................................................................................................................... 85
└ File .................................................................................................................. 85
└ Sensor .............................................................................................................86
└ Device ............................................................................................................. 86
└ Options ............................................................................................................86
└ User Data ..............................................................................................86
└ Remote ................................................................................................. 86
└ Show Cal. Data .....................................................................................86
Global Flags .................................................................................................................. 87
└ S-Parameter Correction ON by Default .......................................................... 87
└ S-Parameter Correction State Locked ............................................................ 87
└ S-Parameter Device Locked ........................................................................... 87
└ Use Flags in Factory Cal. Data Set .................................................................88
Device table .................................................................................................................. 88
Menu bar
Contains the following submenus.
File ← Menu bar
Provides options for loading and saving calibration data files, see:
●
"To change the S-parameter data" on page 90
●
"To load an uncertainty parameter file" on page 91
Configuring basic measurement parameters