Ronde & Schwarz 1304.0004K03, User Manual

Page: 799 / 1071

Remote Commands
R&S
®
FPL1000
799 User Manual 1178.3370.02 ─ 11
OUTPut<up>:IF[:SOURce] <Source>
Defines the type of signal available at one of the output connectors of the
R&S
FPL1000.
Suffix:
<up>
.
Parameters:
<Source> IF
The measured IF value is available at the IF/VIDEO output con-
nector.
This connector is only available if the R&S
FPL1-B5 option is
installed.
The frequency at which the IF value is provided is defined using
the
OUTPut<up>:IF:IFFRequency
command.
VIDeo
The displayed video signal (i.e. the filtered and detected IF sig-
nal, 200mV) is available at the IF/VIDEO output connector.
This setting is required to provide demodulated audio frequen-
cies at the output.
*RST:
IF
Example: OUTP:IF VID
Selects the video signal for the IF/VIDEO output connector.
Manual operation: See "Data Output" on page 302
OUTPut<up>:IF:IFFRequency <Frequency>
This command defines the frequency for the IF output of the R&S FPL1000. The IF fre-
quency of the signal is converted accordingly.
This command is available in the time domain and if the IF/VIDEO output is configured
for IF.
Suffix:
<up>
.
Parameters:
<Frequency> *RST: 50.0 MHz
Default unit: HZ
Manual operation: See "Data Output" on page 302
OUTPut<up>:UPORt:STATe <State>
This command toggles the control lines of the user ports for the AUX PORT connector.
This 9-pole SUB-D male connector is located on the rear panel of the R&S FPL1000.
Setting Basic Spectrum RF Measurement Parameters