A
OPERATING INSTRUCTIONS
15
2. Assembly of the auxiliary handle (See
G&H)
Fig G
1
2
Fig H
1) Locate the auxiliary handle to the
bracket. Note its orientation.
2) Insert the bolt through the bracket and the
handle and screw into the captivated nut.
Tighten using the large adjustment wheel.
OPERATION INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
1. CHARGING YOUR BATTERY PACK
The charger and battery pack are specifically
designed to work together. Do not attempt to
use any other devices. Never insert or allow
metallic objects into your charger or battery
pack connections because an electrical failure
and hazard will occur.
2. BEFORE USING YOUR CORDLESS
STRING TRIMMER
When you charge the new battery or one
which has not been used for long periods of
time, it may not reach full charge until after you
have discharged it fully in use and recharge it
several times.
3. HOW TO CHARGE YOUR BATTERY
PACK (See B)
Connect the battery charger to the power
supply and the green light (20) will illuminate
Then
. fully insert the battery pack into
the charger to make the connections and the
red light (21) will illuminate to show charging
has started . A discharged battery at normal
room temperature will take approximately 1
hour to reach full charge. Charging time may
vary due to variable temperatures and battery
conditions. When charging is completed the
green light (20) will illuminate to indicate end of
charge .
19
21
20
Fig B
Note: green = power on,
red = charging,
Battery pack ingreen = charging
completed
The battery pack can then be removed for use
in your string trimmer. The charger timer circuit
and battery pack temperature safety cut-out
device prevent overcharge of your battery
pack.
When Ni-Cad battery charge runs out
after continuous use or exposure to direct
sunlight or heat, allow time for the tool to
cool down before re-charging to achieve
the full charge.
