PREPARATION
Before beginning installation of product, make sure all parts are present. Compare parts with
package contents list and hardware contents list. If any part is missing or damaged, do not attempt
to assemble, install or operate the product. Contact customer service for replacement parts.
Estimated assembly t ime: 10 minutes (not including plumbing installation)
.
Tool
equired for assembly (not included): Phillips screwdriver, adjustable wrench.
Helpful t ools (not included): Carpenter's level.
ASSEMBLY INSTRUCTIONS
1
A
B
1. Fit and attach backsplash(B)to vanity(A).
Use a construction adhesive (not included)to
attach the backsplash(B) to the wall.
Note:It is recommended you obtain appropriate
recommendations from your local hardware
supplier on adhesive and caulking to be used
.
2
2
rain assembly instructions:
2a.Remove tail piece (G) from drain body (C).
2b.Place flute washer (D) in such a direction as in
the Figure 3 onto drain body (C) and carefully
slide drain body (C) down through the drain
opening from the top of the sink.
2c. Under the sink, slide rubber washer (E) in such
a direction in the Figure 3. onto drain body (C).
Secure drain body (C) to the sink with the nut (F).
DO NOT OVER-TIGHTEN.
2d. Wrap the threads of the drain body (C) engaging
with the threads of the rail piece (G) with pipe
thread tape (not included) for minimum of 2 turns
and screw into drain body (C).
HAND-TIGHTEN ONLY.
2e. Once the complete drain assembly is installed,
connect the tail piece (G) to the P-trap (not
included) and test for leaks. NOTE: Tail piece (G)
can be cut to length if needed.
2f.
Install new or existing faucet (not included)
according to the manufacturer's installation
i nstructions.
IMPORTANT NOTE: The supplied drain must be
used with this vanity sink.
C
D
E
F
G
. D
7
s r
