5
Tool Change
Attention!
Before any work on the tool, disconnect the plug from the mains!
When inserting the tool, you could catch your hands. For this reason,
always wear protective gloves for changing the tool.
The work spindle of the machine has an M 14 - internal thread. Keep
threads and front surface clean.
Please hold up with a jaw wrench 22 to remove the stirring rod.
Tool Protection
Wrong handling can cause damages on the tool.
Therefor, please always observe the following instructions:
Use only stirring rods recommended with M 14 – internal thread (diameter
120 mm max.) which are recommended by the producer.
Do not allow blocking of the tool due to overload.
Only use original accessories.
Switching on and off
Short-Time Operation
Switching-on: press the on/off switch
Switching-off: release the on/off switch
Permanent Operation
Switching-on: press the on/off switch and, keeping it pressed, engage the
arrestor
button
Switching-off: press the on/off switch and let it go off again
