24
11.
Before you plug into the mains, test the panel’s set up:
a.
Water level – is there a gap of 50mm/2 inch at the top of the
tank?
If not, adjust the water level allowing a 50mm/2 inch gap.
b.
Are there any water leaks at the bottom of the tank?
-
If the leak is coming from the orange tube connectors, drain
first and make sure that the tube is fully sealed and connected.
-
If the leak is coming from the drain valve (bottom of the tank),
make sure that it is fully attached and closed properly.
If set up correctly without any leaks, plug the product into the mains
and check the following:
c.
Are both LED Strips working as expected?
d.
Are both Pumps working and are bubbles being produced in
both chambers of the tank?
If so, fit the framework onto the bracket and secure.
12.
Carefully place the framework over the bracket ensuring that all the
metal tabs of the bracket sit within the framework.
Ensure wires and tubing are not pinched and are out of sight within
the cover.