Page
5
of
21
Copyright ROMPA® Ltd
DELUXE VESTIBULATOR 19201, KH 1.15
Please note the following in order to help ensure the safe use of this product:
This swing is intended only to be used with the Deluxe Vestibulator Frame
The client’s weight should not exceed 45kg (100 lbs)
Use the floor mat provided underneath this equipment
ALWAYS supervise the use of these products
REGULARLY check all components for signs of wear or accidental damage and
replace/repair all parts accordingly
Allow adequate space around this equipment
– remove any obstacles or potential hazards
Consider additional floor matting or wall matting if necessary.
Set Up:
1. Connect one carabiner snap ring (like a safety snap) to each height adjuster/ascender.
2. Recline the Seat in the net with the lower front edge of the net covering the lower front
edge of the Seat. The back of the Seat should be fully supported by the net as shown.
3. Lower the unit using the height adjusters/ascenders to facilitate access to and from the
Seat.
4.
Use the positioning straps to help maintain your client’s posture as required.
About the Positioning Seat:
As a Tumble Form
®
, this product is seamless and so resistant to moisture. It is also resistant to
tearing and wear. A slight odour may be noticeable from the manufacturing of this product. This
will disappear after a few days of use
– fresh will replace any air trapped inside when the
cushioning is pressed. Because of the handcrafted Tumble Forms® process, small differences
may occur in the appearance of the upholstery
– any unevenness in the surface will not affect the
strength or moisture-resistance of the upholstery. Each Tumble Forms® module has at least one
vent hole so do not be alarmed if you find small holes in the product. Such vent holes are
necessary to equalise air pressure in the foam. These will help maintain the proper shape and
resilience of your Tumble Forms® module.
To help ensure long-term use of this module, please ensure the following:
Do not use in water
Do not submerge in water to clean
– the interior will absorb and retain water
Use indoors
– outdoor use is permitted in dry, clean environments provided that the module
does not get wet and is brought back indoors after use
Should any water be accidentally absorbed by the module, gently squeeze and press the
module. Allow a few days for any dampness to disappear
Clean using an appropriate, non-abrasive cleaning product
Permanent marker/ballpoint pen markings cannot be removed
Non-permanent ink, wax, crayon, oil, grease, dirt can be rubbed off with a soft, clean and
slightly damp cloth.
FLEXIDISK
