13.
Installation
1.
Find an appropriate location for the Amplifier, bearing in mind that:
-
It needs to be plugged in (an electrical socket required)
-
It needs ventilation around it
-
Proximity to your vibro-acoustic device
-
Proximity to your music source
2.
Connect your music device to the amplifier using the appropriate sockets at the back
of the amplifier:
-
Use the AUX 2 input phono sockets (red and white sockets) when using a
cable connected to the microphone socket of your music system.
-
Use the MIC INPUT socket when using a microphone.
-
Use the 3.5mm AUX 1 input socket on the front of the Amplifier as
necessary, making sure that you adjust the large dial on the right hand
side of the front of the Amplifier to AUX 1.
-
Adjust the large dial on the right hand side of the front of the Amplifier to
Bluetooth if using a Bluetooth device.
3.
Connect the amplifier to your vibro-acoustic device:
-
Use the 6.3mm SPEAKER OUTPUT sockets (LEFT and RIGHT) for connecting
the cables from products such as ROMPA® Musical Water Beds
-
When connecting these cables, make sure the large dial on the right hand
side of the front of the Amplifier is set to AUX 2.
4.
Connect the kettle lead to the socket at the back of the amplifier (top right socket
labelled 240V). Switch on using the rocker switch at the back of the amplifier
(bottom right). The power indicator light on the front of the amplifier should light up
(bottom right hand corner of the front of the amplifier).
