13.
Installation
1.
Choose a suitable location for the projector, bearing in mind the following:
Install indoors in dry environments only
This product requires one electrical socket
Make sure the projection will be onto a suitable surface – a surface free of objects
and white or pale in colour
The projector is a visual product and should not be handled. However, you may wish
to access the projector periodically to change effects or to insert switch jacks etc
There must be unrestricted airflow around the projector, especially around the air
inlet grille.
2.
Use the projector’s bracket to mount the projector. Either:
Suspend from above
Ensure that the bracket is attached to a suitable
surface (that is capable of holding the weight of
the product safely). Fit and secure a safety chain
to an immovable object, with a maximum drop of
30cm. Ensure that all nuts, bolts, hanging bracket
knobs and all other fixings are securely tightened.
Fixed with the bracket flat on an immovable
surface
Make sure the surface is flat, stable and capable of
holding the weight of the product safely. The
bracket has additional screw holes for fine angular
adjustment.
With the bracket as an adjustable stand
Make sure the surface is flat, stable and capable of
holding the weight of the product safely.
3.
Place a suitable accessory in the projector e.g. Wheel Rotator with
an Effect Wheel. Connect these to the 12V~ sockets
on the side of the Projector (if they plug in). Slide the
Wheel Rotator into the rear gate runners (the main
effect goes into the rear gate runners, with
Distortion Wheels etc in the front gate runners).
4.
Connect the IEC lead (kettle lead) into the back of the projector.
Plug in at the wall.
5.
Switch the projector ON/OFF switch to ON.