13.
Installation
1.
The Bumpas are supplied already attached to the back boards.
2.
Attach the back boards to your wall, bearing in mind the following:
The back boards are 5cm thick
Fixtures are not included as these will depend on the construction of your wall
The back boards are solid around the perimeter (the frame is 5cm thick on
each outside edge) but the central part is not solid – take care not to damage
the back boards as these contain electrical components
The approximate weight of the whole product is 50kg for the 115cmH version
and 60kg for the 145cmH version – make sure your wall and fixtures are
capable of holding this weight
Make sure there are no pipes, cables, wires etc behind the wall where you
intend to drill
If using this product with floor cushioning, take into account the depth of the
floor cushion
This product requires one electrical wall socket – make sure the cables on the
power supply will reach the wall socket
Make sure the cables are safe and cannot be pulled and don’t represent a
safety hazard
This product is for indoor use only, in dry environments
If installing this product with other Bumpas, these will be deeper because
these have a back board that the other Bumpas from ROMPA
®
do not
The back boards are very slightly higher than the top of the Bumpas so that
the Bumpas could be attached to it (2 or 3mm approx)
There are additional mirror plates supplied
The Backboard with the Control Box attached must be on the left hand side.
3.
Connect the spade connectors on the cables from the right hand side of the
Backboard with the Control Box on to the spade connectors from the left hand side
of the other Backboard. Observe the labels on each cable. All cables labelled A (and
a number) connect to the corresponding cables labelled A (and a number). The same
applies to the B cables. For example, connect A5 to A5.