RJ45 socket
To select a coloured light press one of the four buttons (red, green, yellow, blue) on the
top. The selected colour will only be activated for a few seconds (the exact time
depends on how you have set the SPEED and DELAY buttons) before the cycle of colours
resumes. The selected colour will not remain indefinitely till another colour is selected
using the switch box. Experiment with the SPEED and DELAY buttons until you find a
setting that best suits your requirements. For example, set SPEED to a minimum to keep
the colour change as slow as possible.
To stop the bubbles press the central button on the top. Release the button to make the
bubbles start again. On the underside of the Switch Box there is a dial labelled BUBBLES
with two options – NORMALLY ON and NORMALLY OFF. Switch between these so that
one way the bubbles start if the central button is pressed and the other way the bubbles
will stop if the central button is pressed.
To adjust the speed of the light change/flash rate use the SPEED and DELAY buttons
underneath labelled COLOURS.
YOU CAN ADD AN EXTERNAL SWITCH (JACK) – When a ROMPA
®
switch is plugged into the
Jack Socket on the side of Push Button Switch Box, most other controls will be over-ridden,
i.e. Push Buttons, Colours etc.
There are nine possible options when a ROMPA
®
switch is used. Use the dials on the
underside of the Super Interactive Switch Box:
1.
With the left hand dial set to COLOURS and the right hand one to FLASH ON, then the
Bubbles will be on all of the time and the Lights will come on when the ROMPA
®
switch is
activated.
