Page
2
of
4
Copyright ROMPA® Ltd
TWINKLE WANDS – SET OF 2 19455, KH 9.10
•
Remove weak or dead batteries
•
Remove batteries if the product will be out of use for long periods
•
Do not attempt to charge non-rechargeable batteries
•
Do not short circuit the supply terminals
•
Do not attempt to dispose of batteries by burning them
•
If using rechargeable batteries, remove them from the product before recharging (if
removable)
Battery Installation
To remove/replace the batteries:
1. Gently remove the outer elastic rubber cover from the plastic handle by peeling back the
cover starting from the large hole end of the rubber cover until the rubber cover clings to
the pull string
2. Use a Philips (positive/cross-head) screwdriver to remove the four screws from the plastic
shell
3. Gently remove the top ‘half’ of the plastic shell to access the batteries
4. Remove and replace the batteries as required
5. Replace the top ‘half’ of the plastic shell and replace and secure the four screws
6. Replace the rubber cover
SAFETY
Always supervise the use of this product.
For 3 years and over (batteries are small parts).
Not suitable for those who mouth
Use in a safe, open safe free of people and obstacles if spinning the wands
TROUBLESHOOTING
In the unlikely event of product problems, please try the following:
•
Check the batteries and replace as required
•
The product is switched on automatically – there is no ON/OFF switch
SPECIFICATION
Meets all appropriate requirements of EN71
Made of plastics and rubber
Uses 3 AAA batteries