HARDWARE BOX CONTENT
1
Please locate and confirm that
you have the following parts:
TR
. toddler rail = 1
one bag of hardware containing the following:
. Allen wrench =
. screw-in dowel = 1
. cam fitting = 1
. Allen bolt (50mm - 1 15/16") = 3
1
2
3
4
1
Required tools:
CAUTION:
Allen wrench (supplied), Phillips
screwdriver (not included), flat screwdriver
Do not use a power screwdriver which
can cause screws to break or strip
(not
included).
Phillips screwdriver (not included)
STEP 1TR
STEP 2TR
STEP 3TR
(Two adults are required to complete this step)
STEP 4
STEP 1
ASSEMBLY INSTRUCTIONS FOR YOUR 8510 STATIONARY CRIB
(Two adults are required to complete this step)
FIGURE 1
(Two adults are required to complete this step)
STEP 1
STEP 4
ASSEMBLY INSTRUCTIONS FOR YOUR 8510 STATIONARY CRIB
STEP 1
(#4)
(#8)
(TR)
(EP)
STEP 2
MS
STEP 3TR
Completely disassemble your crib (follow
to
from
).
For the toddler bed option of your crib you will need only one of the stationary sides so carefully s
into the lower threaded hole from the right side end panel as depicted in
Follow
to
from
to re-assemble your crib.
Use only one of the fixed (stationary) sides described in
.
Use two Allen bolts
and two washers
to attach the toddler rail
to the other end panel
of the crib.
When you reach
adjust the mattress support (
) to its lowest position.
After completing
, your crib should look like the one depicted on the first page of this instruction booklet.
tore the remaining stationary side in a proper place, away from direct sunlight and
moisture, taking care not to scratch the wood finish.
Using a Phillips screwdriver (not supplied) or just the hand, insert the screw-in dowel
(please
see the assembly tip for dowel correct positioning)
Insert the cam fitting
into the inner face of the toddler rail
, taking care that the little arrow of the cam is pointing to the screw-in dowel (please see
).
Using one Allen bolt
, one washer
and the supplied Allen wrench attach the toddler rail
to the right side end panel
then, using the same Allen wrench and moderate
force, slightly rotate the cam fitting
clockwise (see the cam’s rounded arrow) by about 90 deg to 120 deg until become tight.
(2)
(3)
(TR)
FIGURE 1
(#4)
(#8)
(TR)
(EP)
(3)
Do not over tight the cam! This is not a fixture
involved in your child safety.
2
3
4
Summary of Contents for TR 8510
Page 5: ......