LOWEST
POSITION
MIDDLE
POSITION
HIGHEST
POSITION
LOWEST
POSITION
MIDDLE
POSITION
HIGHEST
POSITION
Assemble the mattress support using 4 bigger
round head bolts
, 4
STEP 4
(7)
Do not tighten the bolts completely at
this step, you will be asked to do this later.
"butterfly" type nuts
, 4
smaller lock washers
and a Phillips
screwdriver (not supplied). The lock washer must
be attached to the bolt after the bolt passed
through the frame and the metallic bracket of the
mattress support and before attaching the nut.
There are three positions for the mattress support
(from the highest one for a newborn to the lowest
one for a child that is maximum 35" tall - see
caution note). You must adjust the height of the
mattress support depending of your child height by
inserting all the four bolts in the same position
(see
).
(9)
(11)
FIGURE 4
NOTE:
THE STYLE OF YOUR CRIB OR
OF YOUR MATTRESS SUPPORT MAY
VARY FROM WHAT IS PICTURED IN
T H E
I N S T R U C T I O N
S H E E T
FIGURE 4
7
9
7
9
7
9
7
9
7
9
11
11
11
9
11
To adjust the vertical position of your mattress support you must remove all the four bolts & nuts
loosen all the four bolts
, lower the frame and insert the bolts
back into the corresponding holes,
according to the desired height (see
). Then, you must attach the lock washers
and the nuts
as described in
and tighten all the bolts completely.
A D J U S T I N G
T H E
H E I G H T
O F
Y O U R
M A T T R E S S
S U P P O R T
(7+11+9),
(8+11)
(7)
FIGURE 4
(11)
(9)
STEP 4
ADJUSTED THE HEIGHT OF YOUR
MATTRESS SUPPORT
Your crib is designed in such a manner that, when the mattress support is adjusted to it’s lowest
position, the mattress support frame must be placed directly over the stabilizing bars. Before tighten
the bolts, you must slightly press the mattress support frame to make sure this position is achieved.
WARNING:
IT'S VERY IMPORTANT TO TIGHTEN COMPLETELY ALL THE 8 BOLTS
(7+11+9) & (8+11) AFTER YOU HAVE
.
TO KEEP YOUR BABY SECURE AND SAFE, AND TO AVOID POTENTIAL INJURY OR
DEATH,
11
Summary of Contents for 4510s
Page 2: ......
