AgraStrip
®
Mycotoxin WATEX Quick Guide
Result Interpretation
A color line always appears in the upper
section of the test strip to indicate that
the test strip is working properly. This line
is the control line.
Invalid results:
If there is no control line in the control
zone, the test is invalid and the sample
should be re-tested by using a valid test
strip.
Valid results:
2 lines are visible. The intensity of the line
in the test zone is indirectly proportional
to the mycotoxin concentration and has to
be measured with the AgraVision™.
Add 30 ml of distilled
water to the Filter
Whirl-Pak
®
Bag.
Weigh-in 10 g of ad-
equately ground, rep-
resentative sample
and add one Extrac-
tion Buffer Bag into
one side of a Filter
Whirl-Pak
®
Bag.
Preheat AgraStrip
®
Incubator for about
30 minutes until
'*+56
Shake vigorously for
2 minutes.
Put a test strip into
each well, close the
AgraStrip
®
Incuba-
tor lid and allow
the strip to develop
color for 3 minutes.
Wipe strip onto an
absorbent paper
and immediately
read with
AgraVision™ reader.
Let sample settle for
2 minutes.
79
assay dilution buffer
in a dilution tube.*
Put microwell into
the AgraStrip
®
Incubator and add
100 μL diluted
sample extract.
Mix the content by
pipetting it up and
down 10 times.
Read the Package Insert instructions completely before performing any test.
'
<'7=!>
extract and transfer
into the dilution tube.
7
8
9
10
Procedure of AgraStrip
®
Mycotoxin WATEX on corn
*May differ depending on kit type and application. Please refer to the respective application brief
4
3
2
1
HJK
KN$
+
OYKOZK[K\J]
!" #
^_ `N`_^
T
{"'|"|^
F
{"'|""^
E
=}+~!6+!
! $% &
· Tulln, Austria ·
T
{"'""^
F
{"'"""^
E
=}+>~!6+!
! # !#
· Singapore ·
T
{'"||^
F
{''''|^
E
~!6+!
>$5]
!9#% J! `
'''#(#
! &)& $