
26
PREPARING A COFFEE
The machine will only work with 123 SPRESSO
®
pods.
1 - Fill the tank with fresh water (no. 7).
2 - Connect the power cable.
3 - Switch the machine ON using the button on the back (no. 8).4 - If the white light (no. 3) is flashing,
the machine is heating.
5 - When the machine reaches the required temperature, the white light (no. 3) will stop flashing and stay ON
steady.
6 - Open the coffee pod packaging, remove the foil lid and take out the pod.
7 - Insert the pod in the machine (raise handle no. 2 first).
8 - Then lower the handle (no. 2).
9 - Press the Small coffee (no. 4) or Large coffee (no. 5) button, as preferred.
The coffee cycle stops automatically at the end of the cycle or manually if the selected button is pressed. When
the coffee is ready, raise the handle (no. 2), the used pod will fall into the used-pod tank (no. 9). The machine is
then ready to make another coffee.
PROGRAMMING
The 2 coffee options (small or large) are pre-programmed by default (6 cl for a small coffee and 12 cl for a large
coffee). You can change these volumes as follows:
1 - Start the machine (button no. 8). The white light must stay ON (the machine is at the right temperature, ready
to make coffee).
2 - Raise the handle (no. 2) and insert a pod.
3 - Press and hold the «Small coffee» and «Large coffee» buttons (buttons no. 4 and no. 5) simultaneously for at
least 5 seconds. The white light will then flash rapidly - the machine is in programming mode.
4 - Lower the handle (no. 2) and press the coffee option to be programmed (button no. 4 for small coffee and
button no. 5 for large coffee).
5 - Once the required volume of coffee has been poured, press the same button again to stop serving and save
the selected volume.
6 - The white light will then stay ON - the programming has been saved for the button.
ANOMALIES
I CAN’T MAKE COFFEE.
Check that the switch (no. 8) is set to I.
Check that the white light is ON steady. You cannot make coffee while the machine is heating, this is normal (the
white light will flash slowly).
Check that the machine is not on standby. If so, press a coffee button (no. 4 or no. 5), or use the handle (no. 2,