INSTALLATION INSTRUCTIONS
The R-1000 Command center includes four components: The keypad, temperature probe
and the power unit.
INSTALLATION OF THE POWER UNIT
The power unit is equipped with brackets, allowing it to be attached onto a surface.
Locate the power unit, in an upright position with the wires coming out of the bottom, as
close to the steam unit as possible.
(See
attached wiring diagram)
NOTE:
Cables for the keypad and thermostat are 25 feet in length and can not be
extended. It is essential that the power unit be located no further than 25 feet away
from the shower.
INSTALLATION OF THE KEYPAD
The keypad should be recessed into an inside wall of the shower in an area easily reached
by the user.
(1) Set a 4’x 4’ 2 gang box midway up the shower wall to accommodate the control.
(2) Attach the keypad to the 2 gang box with the 4 screws provided.
NOTE: Make sure that the keypad cable is securely plugged in before attaching to
the gang box. (See fig. 2)
INSTALLATION OF THE TEMPERTURE PROBE
The temperature probe should be located approximately 6 inches from the ceiling in the
wall furthest from the shower door.
(1) Using a 5/16” drill bit, drill a hole through the tile surface to accommodate the probe.
(2) Slide the probe through the hole allowing the entire metal tip to protrude into the
shower area.
(3) Once the probe is through the hole, grout the hole closed around the cable.
NOTE:
It is important that the metal tip stick straight out away from and not
touch the surface of the wall. If the metal tip is touching the wall, the sensing device
will receive a false reading and will not be able to accurately sense the temperature
inside the room.
Page 2
Summary of Contents for R-1000
Page 1: ...Page 1 ...
Page 3: ...Page 3 ...
