Adjustments
Tiller Angle Adjustment
On the left side of the base of the tiller
there is a red lever. Push the lever in to
release the pin and select the required
tiller angle.
When the desired angle is set, refit the pin
into one of the five locating holes.
Caution! Ensure the tiller is properly
locked into position before driving the
scooter.
Seat Slide Adjustment
Pulling up on the lever allows the seat
position to be adjusted forward or
backward. Releasing the lever will lock
the seat in position.
Seat Swivel Adjustment
Under the right of the seat is a red
lever. Pulling up on the lever allows
the seat to swivel to either side,
allowing for easy manoeuvring on or
off the scooter.
Do not drive the
scooter if the seat is not locked in
the forward position.
Seat Height Adjustment
To adjust the height of the seat, undo
the seat-tightening knob under the front
of the seat.
Pull the swivel adjustment lever
upwards and at the same time lift the
seat from the adaptor.
Remove the seat height-locating pin and
set the seat adaptor to the desired
height and reset the locking pin.
Reverse the above instructions to
replace the seat and re-tighten the hand
knob.
Armrest Width Adjustment
On the underside of the seat there are two hand knobs. Releasing the hand
knob allows the arms to be adjusted to the required width, or removed for
transportation.
Ensure the knobs are fully tightened before driving the scooter. Do not
drive the scooter without the arms fitted.
Slide
Lever
Swivel
Lever
Armrest Width
Adjustment Knob
Page 5
