Part No 4801-5162 Rev 09-2019
RS-500/600 M Series Doors
Page 43
26
Removing and Replacing Floating Magnets or Velcro
NOTE: The door shown in the following illustrations may have different options and accessories than your door.
Removing and replacing the floating is the same for all RollSeal units.
Diagram 26A
1.
Turn off controller or remove power to the
door.
2.
Open the door to its upper limit. It will be
necessary to raise the panel as high as it
will go into the head unit. Refer to the
appropriate Operator Manual (4801-5161
RollSeal SC-325M & SC-650M
Controller Manual. This will make it
easier for you to remove and re-install the
“Floating Magnets or Velcro and PIM
Plate Assemblies” from the left and right
side tracks (
).
Warning!
Ensure power is turned “OFF” to prevent door movement while removing
PIM Plate Assembly and Floating!
!
