4801-5179B
9 February 2021
8
RS-200 Manually Operated Door Installation Manual
1. Lift the door assembly, then walk the legs backward until it reaches the clear opening.
2. With someone holding each track in place, align the left track with the opening.
3. Use a level to ensure the track is plumb.
4. Install the door assembly by running the stitch screws included in the hardware kit through the prepunched holes in the track.
5. Repeat Steps 2-4 on the right track.
6. Install the eight hex-drive rivets as follows:
a. Drill a 5/16" wide by 1-1/2" deep hole into the wall.
b. Blow all debris out of the hole.
c. Insert the rivet, then use a 5/8" box wrench to hold the washer head while tightening the rivet using a 5/16" bit.
d. Remove all debris from the perimeter of the hole.
e. Repeat Steps 6a-6d on the remaining rivets.
Section 2.3: Mount Door to Wall
7. Use a square to ensure each track is flush with the face of the wall and the floor.
8. Install a cement screw (supplied in the hardware kit) in the prepunched hole in the bottom brace on each side.
