CONNECTION
Connect the AC cord to a properly grounded ac outlet.
Determine which input configuration you will use; either discreet right/left, TRS
stereo, or mono.
For a discreet right/left input configuration, connect a 1/4” TS plug containing the
“Right” portion of the stereo signal to the Right Main Input. Connect a 1/4” TS plug
containing the “Left” portion of the stereo signal to the Left Input.
For a TRS stereo input configuration, connect a Tip-Ring-Sleeve stereo plug into
the front panel STEREO IN input. This cable may come from a mixer’s headphone
output for example.
To send a mono signal to the RA62, connect a 1/4” Tip-Sleeve plug into either the
Right or Left input and press in the front panel MONO/STEREO switch. This mono
signal will be fed to both the right and left sides of the headphone outputs.
The Aux Inputs are connected in the same manner as the discreet right/left input
configuration listed above.
INSERTS
The inserts have been provided so you can directly access each headphone
output with its own program material.
The inserts
require Tip-Ring-Sleeve connectors, with right and left signals on the
tip and ring respectively. If you use a TS mono plug - you will only hear sound out
of one side.
When these insert jacks are used, the main Right/Stereo and Left/Mono, as well
as the Aux Inputs - are disconnected. Only the stereo signals sent to the Insert
jacks go to that corresponding output.
CAUTION: Plugging a mono 1/4” TS plug into the Headphone
Outputs may cause permanent damage to the unit because
one side would be shorted to ground.
Never plug a mono plug
into any of the Headphone Outputs.
3
4
Tip
Ring
Sleeve
(ground)
DESCRIPTION
FRONT PANEL
VOLUME
OUT
VOLUME
OUT
VOLUME
OUT
VOLUME
OUT
VOLUME
OUT
VOLUME
OUT
MONO
STEREO
PAN
STEREO
INPUT
PWR
HEADPHONE
AMPLIFIER
RA62
Note: Descriptions for Channel One through Channel Six are identical.
OUT 1 - 6 : 1/4” Tip-Ring-Sleeve jack for connection to a standard pair of head-
phones.
VOLUME 1 - 6: Controls the amount of output signal from the indicated channel.
MONO/STEREO SWITCH: When this switch is pressed in, the Right and Left
channels are summed together providing a mono output signal.
PAN: Controls the relative amount of signal sent to the Right and Left output
channels.
STEREO IN: 1/4” TRS input jack which paralells the rear panel Right and Left
input jacks.
POWER LED: Indicates that the RA62 is connected to the power supply and is
on.
REAR PANEL
INSERT 1
INSERT 2
INSERT 3
INSERT 4
INSERT 5
INSERT 6
RIGHT
LEFT
LEFT
RIGHT
120 VAC
50/60 Hz 15 VA
MADE IN U.S.A.
RISQUE DE CHOC - NE PAS ENLEVER
MODEL RA62
SERIAL NUMBER
62-
WARNING:
DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE.
TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT NOT REMOVE BACK.
NO USER SERVICABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL
MAIN INPUT
AUX INPUT
NRTL /C
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
120 VAC INPUT: Connects to a properly grounded AC outlet.
MAIN INPUT: 1/4” TRS jacks for connecting to the desired Right and Left program
material.
AUX INPUT: Additional 1/4” unbalanced inputs - for use in the event
Note: The description for the Channel Inserts pertains to all six channels.
CHANNEL INSERTS:
