FEATURES:
• 10 FM and 10 AM presets
• Retains presets when power is off
• LCD digital display
• 1 space EIA 1/2 rack chassis
• Output Level control
• RCA and XLR balanced line level outputs.
• FREQUENCY DISPLAY: LCD display showing the active information relevant to the current
operation of the HR78X.
• M1-M5 PRESET STATIONS: Selects and Stores the Preset stations. (M+5 must be used for access
-
ing presets 6-10)
• M5+: For accessing M6-M10 presets.
• Mono/Stereo: Selects between Stereo and Mono FM operation.
• BAND: Selects between the FM preset, and the AM preset band. FM1-FM2-AM
• MEM: When the desired station is selected, this button is pressed, followed by the desired Pre
-
set Station number, then MEM again to Store the preset.
• VOL: Adjusts the output level of both the RCA and
XLR balanced line level outputs. PLEASE
NOTE: FOR A LINE LEVEL OUTPUT, SET THE LEVEL CONTROL AT APPROXIMATELY 3 O'CLOCK.
• TUNING (- and +): Selects the stations that the HR78X is receiving. Pressing and holding the +
or - buttons will auto search for the next station.
HR78X DISPLAY
-Band indicator and number.
-Stereo (ST) indicators. Indicates whether the HR78X FM Mode is operating in Stereo or Mono.
-Preset number (CH)- indicates which preset has been selected.
-Station frequency indicator
• 15 VDC USE ROLLS SUPPLIED PS27s ADAPTER ONLY!!!
• Stereo RCA Outputs .
• XLR balanced line level outputs.
• FM ANT. 75 Ohm: Connects to the included 75 ohm FM antenna.
• AM LOOP ANT. 300 Ohm Connects to the included 300 ohm AM Loop antenna.
+
-
15 VDC
HR78X
INDOOR FM ANTENNA
• Connect the antenna to its corresponding input on the rear panel of the HR78X. While listen
-
ing to a broadcast, move around until the antenna is facing a direction where the signal comes
in the strongest. Secure the antenna in this position.
OUTDOOR FM ANTENNA
• Installation of an outdoor FM antenna is recommended for a very high quality FM reception.
• The lead-in antenna cable should be of the 75-ohm coaxial type as it suppresses intrusion of
noise more effectively than the 300 ohm twin lead type.
• The cable should be straight and as far away from power lines as possible. Cut off any extra
length.
PROGRAMMING PRESETS
Select the AM or FM band you wish to program (AM, or FM). Using the , or TUNING -
buttons to select the station you wish to program. To store that station in a preset (1 - 10), press
the MEM button followed by the Preset Number button you want that station stored to. Then
press the MEM button once again to store the preset. (M+5 must be used for accessing presets
6-10)
You may repeat this process for all 10 FM presets, and 10 AM presets.
