1. VS1 Mounting carriers
A.
Make sure to set the position of the carrier as close as possible to the control.
Select the same mounting distance of the carrier on the opposite side.
Please note a max. carrier spacing of about 50 cm.
B.
Screw down the carriers at the determined position. Lever the pleated blind into the carrier
with an audible click.
2. Mounting clamping shoe VS1 / VS2
C. Please ensure, that the system cord runs through the rear slot of the clamping shoe. If the
Pleated blind's tension is too low please tie a new knot to the left AND to the right. After proper
Installation carefully cut the protruding cords.
D.
Position the screws for the clamping shoe 17mm from the outer edge of the glass rebate or pleated blind
and screw them on slightly. Slide the clamping shoes onto the screws and tighten them hand tight.
