• The Puro comes with 1x standard filter and 1x sponge filter preinstalled within the Canister.
• The Puro comes with the battery pack preinstalled within the main body of the vacuum.
• The Crevice Tool comes with a sliding brush attached.
• The Connector may come already attached to an attachment. Pull it out to remove it.
• The Charging Base may come unassembled. Push the top piece into the bottom to assemble.
• Charging longer than 5.5hrs may affect battery life.
• Batteries perform best after several full charge/discharge cycles.
• If the Puro doesn’t charge, ensure the adapter is securely connected to its power source.
• If you misplace your adapter and/or Charging Base, visit www.rollibot.com for a replacement.
The Puro comes with a preinstalled 2200mAh,
lithium-ion rechargeable battery . Before using your
vacuum for the first time, the battery must be charged.
The battery is charged when the Puro connects to its
Charging Base. Ensure the Charging Base is assembled
first; the top and bottom pieces will snap into place. After
assembly, see the following images and instructions.
Place the Charging Base on the floor.
Place the vacuum into the base so that the
contacts on vacuum’s underside and the contacts
on the base of the Station connect.
Check the adapter for the correct information
(Input 100-240V~50/60Hz 0.5A & Output 26.0V 450
mA) then plug the adapter into the wall.
Charge for 5.5 hours.While charging, the Indicator
will turn red and blink.
When the Puro is fully charged, the Indicator will
stop blinking. Turn off the Puro if it will not be used
immediately.
Use the back of the base to manage adapter cables
as desired.
Use the compartments in the base to store
attachments as desired.
Section 3. Charging Instructions
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Step 7
04
