Rollei HS Freeze 4s, Instructions Manual

Page: 35 / 144

35
Quick Menu
Press the second function button from the top and turn the power output
button to adjust the channel number. This can be set from 00 to 15.
Press the third function button from the top and turn the power output button
to adjust the group. Here you can choose between A/B/C/D/E/F/G/H/I/J.
Press the fourth function key from above for two seconds to activate RT
mode. Then press the fourth button again briefly to set the Canon* ID
between 00 and 99. The Rollei HS Freeze 4s and a Canon* (RT) flash can be
synchronized if the channel and ID are the same.
Press the second function button from the top to activate the beep. Here
you can turn the function on and off. If this is turned on, the flash will make
indication sounds and the icon is shown on the display.
Infrared Slave Mode: Press the third function button from the top side to
activate or deactivate the slave mode function. If this function is activated,
the icon will be shown on the display. The flash is then able to release a
flash strobe as soon as another flash is fired. For this function the infra red
sensor should not be hidden.
Modeling lamp: Press the fourth function button from the top to activate
the modeling lamp. Press it once for the proportional mode [ PRO] and
the modeling lamp‘s intensity will match the power setting on the flash
unit. Press the button again to enter the independent mode [ 1.0 ~9.0]
in which you can set the power of the modeling lamp individually from
1.0 to 9.0 by turning the power output wheel. To deactivate the modeling
lamp press the Power on/off button.
CH
GR
ID/RT
ID/RT