14
| Automate
™
Programming Instructions | Modular Curtain Motor
ROLLEASE ACMEDA
7.2.1
Check/ Change motor direction (initial set up)
Press
P1
on Motor for 10 seconds to enter setting mode
The AUTOMATE Modular Curtain motor features automatic limit detection. Once the motor is attached to a
fabricated, installed track, limits can be set with a few simple actions.
Note:
Changing motor direction after initial set up (with limits already set) will clear the limits.
Open and close the curtain to re-set the limits automatically.
To reverse direction, hold both
UP
and
DOWN
. Until the motor
responds.
Approx.
Approx.
Motor Response
Motor Response
P1
Approx.
Approx.
10
Approx.
7.3
Auto Set Limits
Press the
UP
or
DOWN
buttons on controller.
Carrier will run to the end of the track.
When carrier has reached the end of the
track, it will automatically set limit there.
Repeat for opposite end.
Motor Response
OR
To verify limits were successfully set, press up or down to run to limit. Motor should now function with slow
start/slow stop feature. After the limits are set, the motor will only move in the set limit range. If the motor
encounters a new obstacle a maximum of THREE TIMES at the same position, the limit will automatically reset.
IMPORTANT
Initial set-up is now complete
Note: If the motor encounters an obstacle, collision detection will stop the motor to prevent damage.
