Rolando Texart XT-640, User Manual

Page: 146 / 156

An Error Message Appears
6
FA
Q
144
[AVOIDING DRY-UP TURN POWER OFF]
The print heads were forced to the home position to prevent them from drying out.
Operation cannot be continued. Switch the sub power off, then back on.
[SET HEAD HEIGHT TO xxx]
The height of the print heads is lower than the height specified in the software RIP.
This warning indicates that the height of the print heads is too low for the media thickness specified in the
software RIP. The print-head carriage moves to a location where you can operate the height-adjustment lever.
Adjust to the displayed height, then press
.

P. 106 "Adjusting Print Head Height to Match Media Thickness"
[MOTOR ERROR TURN POWER OFF]
A motor error occurred.
Operation cannot be continued. Switch off the sub power. Next, eliminate the cause of the error, and then
immediately switch on the sub power. If the machine is left with the error uncorrected, the print heads may
dry out and become damaged. This error may be caused by such factors as a mistake when loading the media,
a media jam, an operation that pulls the media with excessive force, or an operation where the print heads
were manually moved
The media has jammed.
Carefully remove the jammed media. The print heads may also be damaged. Perform head cleaning, and then
perform a printing test and check the results.
The media was pulled with excessive force.
Excessive tension was applied to the media, and additional action is necessary to recover from this state. First,
raise the loading lever and adjust the media to create a small amount of slack, then switch on the sub power.
The print heads were moved manually.
This message may occur if the front cover was opened and the print heads moved manually. Close the front
cover, and turn the sub power off.
[PINCHROLL ERROR LOWER PINCHROLL]
This message appears when the loading lever was raised during initialization or after the
media was loaded.
The error is cleared automatically after a short wait. Load the media correctly again.
[WRONG HEAD IS INSTALLED]
An unusable print head has been installed.
Operation cannot be continued. Switch off the sub power and contact your authorized Roland DG Corporation
dealer.
[CANCELED FOR MOTOR PROTECTION]
The initial ink filling operation after purchase was interrupted and restarted before 10 min -
utes had passed.
Press any key other than the sub power switch to clear the error message. Leave the machine alone for ap-
proximately 10 minutes before resuming operation. Initial ink filling after purchase requires the pump motor
to turn for a long time. To prevent failure due to the pump overheating, wait at least 10 minutes after the
operation was interrupted before restarting.