Mounting on the Hi-Hat Stand
7
6.
Attach the clamp and holder to the pipe on the
upper part of the hi-hat stand, then slightly
tighten the assembly with the drum key.
Slightly tighten
7.
Pass the ends of the holder through the grooves
in the metal portion of the bottom hi-hat, then
while strongly pulling the clamp downward,
secure it with the drum key.
Pull down and tighten
* Not pulling strongly enough on the clamp can make
the bottom hi-hat unstable, causing it to shake or
turn, and prevent proper functioning.
* After extended use of the hi-hat stand, the stand’s felt
(or rubber) pad on which the bottom cymbal rests
becomes compressed, which may cause the bottom
hi-hat to become unstable. If this occurs, loosen the
clamp bolt and perform Step 7 again.
(3) Assembling the Overall Unit
1.
Place the top hi-hat assembly on the hi-hat stand
with the cymbal rod passing through the top
hi-hat hole.
At this point, position the “Roland” logo on the farther
side, as viewed from the performer.
2.
Use the link cable to connect the bottom hi-hat
and the top hi-hat LINK jacks.
3.
Pull the bend of the cable softly with your
fingers.
* Make sure that both the top hi-hat and bottom hi-hat
can be closed smoothly.
