5
When mounting the CY-5 on an L-Rod (pad mount),
use ONLY the attachment set as shown below.
Acceptable rod diameters:
10.5–11.5 mm (7/16 to 1/2 inch)
1.
Mounting the lower clutch and the clutch felt
(L).
Align the notched section as shown below. Then place the
clutch felt so it fits securely.
2.
Mount the CY-5 so it fits the lower clutch as
shown below.
3.
Place the clutch felt (S), and while applying
some pressure, mount the upper clutch as
shown.
Afterwards, you can adjust the upper clutch to have the
movement you desire. If it is too loose, double triggering
may occur.
Be sure the Roland logo is on the opposite side of the
playing area.
4.
Use the included connection cable and connect
the output jack of the CY-5 to the trigger input
jack of the percussion sound module.
Connect the L-shaped plug of the included cable to the
CY-5.
To make use of edge shot and choking play techniques,
you’ll need to connect to a trigger input jack on the
percussion sound module that accommodates rim shots
(p. 6).
921
* To prevent malfunction and/or damage to speakers or other
devices, always turn down the volume, and turn off the power
on all devices before making any connections.
5.
Secure the cable with the provided cable tie to
the stand pipe.
Leave enough slack, so that the pad can still move freely
without pulling on the cable.
6.
For the CY-5 to function correctly, the trigger
type in the sound module must be adjusted.
See page 6.
Using the CY-5 as a hi-hat pad
Upper Clutch
Clutch Felt (L)
Lower Clutch
Clutch Felt (S)
Notch
(Be sure to
orient it correctly)
Tighten the bolt with
a drum key.
Projection (Be sure to
orient it correctly)
Tighten the bolt with
a drum key.
Apply pressure
Secure the cable in place
with the cable tie
Leave some
slack in the cable
CY-5_e 5 ページ ２００６年１月８日 日曜日 午後６時１０分
