Roland TrueVIS VG3-540, User Manual

Page: 324 / 341

To continue performing output without making corrections, tap [Continue Output]. The data is output
without printing the crop marks.
To cancel output, tap [Cancel]. Make the printing area wider, for example, by replacing the media with a
larger piece of media, and then send the data again.
The size of the data being output is too small.
Make the horizontal-direction (scan-direction) size of the data at least 60 mm (2.6 in.). To continue per-
forming output without making corrections, tap [Continue Output]. At this time, the data is output with-
out printing the crop marks.
To stop output, stop sending data from the computer, and then raise the loading lever. Increase the size of
the data, and then send the data again.
There is no limitation on the size of the data in the media-feed (FEED) direction.
MEMO
[Motor Error]
A motor error occurred.
Operation cannot be continued. Turn off the sub power. Next, eliminate the cause of the error, then imme-
diately switch on the sub power.
If the machine is allowed to stand with the error uncorrected, the print heads may dry out and become
damaged. This error may be caused by such factors as a mistake in loading the media, a media jam, or an
operation that pulls the media with excessive force.
The media has jammed.
Carefully remove the jammed media. The print heads may also be damaged. Perform head cleaning, and
then perform a printing test and check the results.
Has the media been pulled with excessive force?
Excessive tension was applied to the media, and additional action is necessary to recover from this state.
First, raise the loading lever and adjust the media to create a small amount of slack, and then switch on
the sub power.
[Print Head Dry-out Error]
This message appears when the print heads are forced to the home position to prevent them from
drying out.
Operation cannot be continued. Switch the sub power off, and then back on.
[Low Temperature Error]
The temperature of the location where the machine is installed has fallen below the ambient temper-
ature at which the machine can operate.
This message appears when the temperature falls to 5°C (41°F) or lower during startup or to 2°C (35.6°F)
or lower during operation.
Operation cannot be continued. Turn off the sub power.
The displayed temperature is the current ambient temperature of the installation location. Bring the in-
stalled location to a temperature at which operation is possible (20°C to 32°C [68°F to 89.6°F]), allow the
machine to come to room temperature, and then turn on the power.
RELATED LINKS
Error Messages
Messages on the Operation Panel
323