Owner’s Manual
The TD-12KV includes the contents of the TD-12K set (see TD-
12K owner’s manual, p. 5) with the addition of the following
items.
❑
CY-12R/C (V-Cymbal Ride/Crash) x1
❑
MDY-10U (Cymbal Mount) x1
❑
Connection Cable x1
❑
TD-12KV Owner’s Manual (this manual) x1
After you’ve made the connections described in “Assemble the
TD-12K” on p. 13 of the TD-12K owner’s manual, make
connections as follows.
1.
Attach the CY-12R/C and MDY-10U to the MDS-12
as shown in the illustration.
2.
Connect the “I” shaped plug of the included cable to
the CR2 cable of the MDS-12 at location (A).
* If you wish, you can also connect to AX2 (AUX2) where
Splash sound is assigned instead of connecting to
CRASH 2.
3.
Connect the “L” shaped plug of the cable to the
BOW/EDGE output jack of the CY-12R/C.
4.
Secure the cable with cable ties.
Leave enough slack so that the cable is not pulled by any
shaking or vibration of the cymbal when it is struck.
A cable tie is included with the CY-12R/C.
Take care to ensure that the cable does not come into
contact with the cymbal or stand. Contact between the
cable and the cymbal or stand can result in problems,
such as double sounding.
Thank you, and congratulations on your choice of the
TD-12KV Roland Drum System.
After reading the TD-12K owner’s manual, please
make connections as described in “Connecting Crash
2,” below.
Check the Contents of the Box
Connecting Crash 2
CY-12R/C
CY-12R/C
MDY-10U
(A)
CR2 Cable
“I” shaped Plug
(Jack type)
BOW/EDGE
Output Jack
BOW/BELL
Output Jack
“L” shaped
Plug
Tighten it
not to slip
Wind the cable
tie twice
Secure the cable in place
with the cable tie
Leave some
slack in the
cable
Turn back
to fix the
cable
40785834 1PD
Copyright © 2008 ROLAND CORPORATION
All rights reserved. No part of this publication may be reproduced in any
form without the written permission of ROLAND CORPORATION.
