7
Using the S-4000 System
DB-25 Cable Protector
Install the slide-on connector guard on the S-4000H front panel to provide protection
for the DB-25 input and output connectors. When installed, the connector guard will
support DB-25 connectors that are plugged in the front panel, and prevent them from
being bent due to accidental stress or the weight of the connector’s cable.
1.
Turn off the power on all equipment and disconnect all cables from the S-4000H
unit.
2.
Slide the DB-25 connector guard over the S-4000H front-panel lugs as shown.
3.
To hold the connector guard in place, use the supplied screws as shown.
See the S-4000S Owner’s Manual for details.
Using the S-4000H
Make sure that the connector
guard is installed as shown in
the above illustrations. If its
orientation is reversed, it won’t
remain attached.
S-4000H_e_book 7 ページ ２００５年１１月２１日 月曜日 午後４時４７分
