14
RD-150
Nov, 2000
TEST MODE
The following devices are required:
- MIDI cable
- An oscilloscope
- Damper and Soft pedals
- EV-5 Expression Pedal.
HOW TO VISUALIZE THE INSTRUMENT SOFTWARE VERSION
Turn the power on while keeping the [POP PIANO] button pressed.
After a few seconds the 7-segment display visualizes:
Turn the power off to exit Test Mode
FACTORY SETUP
Turn the power on while keeping the [PLAY] and [REC] buttons pressed.
After a few seconds the 7-segment display visualizes:
The Factory function re-establishes the instrument's default settings.
HOW TO ENTER TEST MODE
Turn the power on while keeping the [PIANO] button pressed.
After a few seconds, the display will show the Test Mode main menu, visualising the following
writing:
TEST RD-150 VERSION 1.00
The LEDs relative to Piano, Pop Piano, Rock Piano, Honky Tonk, Stage Rhodes, Sa Rhodes
timbres light up, indicating the test to be carried out. As far as the tests are carried out, the
corresponding LEDs will turn OFF.
1) Piano
Switch and LED Test
2) Pop Piano
Memory Test (FLASH, RAM, Wave ROM, Effect RAM)
3) Rock Piano
Adc Test
4) Honky Tonk
Keyboard Test
5) Stage Rhodes
Midi Test
6) Sa Rhodes
Audio Test
Turn the power off to exit Test Mode.
fe8
100
1) LED AND SWITCH TEST
Press the [PIANO] button.
The display visualizes:
All the LEDs on the panel are on.
Press one by one all the switches on the panel so as to turn the corresponding LED off.
Every time you press a switch, you hear a sound indicating that the contact has been established.
The LEDs turn OFF and ON in sequence. When you press a button having no LED connected
(Data + and Data -), the segments of the upper and lower part of the display will turn off.
Note:
If you press the [Data + Data -] button in sequence, the display segments turn off
alternatevely and you hear a sound. If you keep it pressed, the display segments turn off
one after the other very quickly and you do not hear any sound.
Note:
If this test is not carried out completely, it is not possible to go on to the following step.
When all the LEDs will be off, the Master screen will be shown on the display, indicating which test
has to be carried out immediately after:
You can leave the Switch/LED test, pressing the [CLAV] and [PIANO] buttons at the same time.
Note: If you do not carry out the Switch test, the display visualizes the writing "Sut " every time you
press the [CLAV] button, until you perform it.
2) MEMORY TEST
Press the [POP PIANO] button.
The DEVICE CHECK is automatically carried out by the CPU board.
The result of the test is visualized on the four LEDs corresponding to the name of the buttons
described below.
If a DEVICE is damaged, the corresponding LED flashes, otherwise it stays on.
If at least one DEVICE is damaged, the writing Err is visualized on the display, otherwise Yes is
visualized.
The LEDs' associations are the following:
E F F
9E5
S U E
M E M
8.8.8.
