
PNS-135 ASSEMBLY INSTRUCTIONS
* The shafts are required to load roll material. To install,
please refer to the User's manual included with the
ColorCAMM PRO.
Rear of
ColorCAMM PRO
Accessories
2
The required installation spaces for each model are listed below.
1500 mm (59-1/16") high, 1500 mm (59-1/16") wide,
and 750 mm (29-1/2") depth
Also, because the sheet moves during cutting, be sure that no
obstacle is located any closer than 600 mm (23-5/8") to the front
or back of the unit.
Assembly Instructions
Installation
Unpacking, installation, and moving must be carried out by
two or more persons.
Failure to do so may result in falling of the unit, leading to injury.
Use the joining screws to secure the unit to the stand.
Failure to do so may result in falling of the unit, leading to injury.
Use care to avoid pinching the fingers when placing the unit
on the stand.
Doing so may result in injury.
1
Refer to the figure below to stand up the stand legs, and position the stays against the
stand legs so that the stays are lined up with the holes.
2
Tighten the hexagon-head socket screws (2) for the stand legs and stays so that they
are finger-tight.
3
Install the mounting fixtures on the ends of the stand legs.
4
Carefully swing the stand upright so that its feet are on the floor.
5
Securely tighten the provisionally tightened screws for the stand legs and stays, and
cap the tightened
screws.
Place on top.
Hexagonal
wrench (large)
Hexagon-
head socket
screws (1)
Stand
ColorCAMM PRO
3
Hexagon-head
socket screws (3)
Protruding hole
Lock the
caster locks.
Mounting fixtures
Stays
Stand legs
Hexagon-head socket screws (3)
Stand legs: 2
Hexagonal wrench (small)
Hexagonal
wrench (small)
Stay: 2
Shafts: 2
Mounting fixture: 2
Sheet
hangers (L/R): 2
Hexagon-head socket
screws (1) : 4
(for mounting the main unit)
Hexagonal wrench (large) : 1
(for screws (1), (2))
Hexagon-head socket
screws (2) : 8
(for stand assembly)
Hexagonal wrench (small) : 1
(for screws (3))
Hexagon-head
socket screws (3) : 10
(for mounting the sheet hangers
and mounting fixtures)
Plain washers: 8
Plain washers
Stand legs