Roland Octa-Capture, Instruction Manual, Page: 14 / 14

14
Appendix
Troubleshooting
Problem Cause
Can’t sync the VS-700 and the OCTA-
CAPTURE.
Did you use VS-700 I/O Editor or the Control Surface plug-in to set DIGITAL 1 INPUT SOURCE to COAXIAL IN, and set SYNC to
DIGITAL1?
Have you connected the coaxial cable to the VS-700’s COAXIAL IN?
Can’t monitor the OCTA-CAPTURE’s output
through headphones.
Did you make patchbay settings from the OCTA-CAPTURE’s control panel?
When updating the VS-700’s system
program, the input indicator blinked
when you connected the USB cable to
your computer, and the update could not
be performed.
After powering up the VS-700, did you return the SW1 “4” switch to the “off” position?
You performed the VS-700C console
update as directed by the manual, but it
was not successful.
Could a device other than the VS-700C be connected to the computer?
If the VS-700R is connected to your computer when updating the VS-700C, updating the VS-700C will not be successful.
2PS