Roland monoFab SRM-20, User Manual

Page: 15 / 152

15
VPanel (Operation Panel)
Setup Dialog
This dialog is displayed when setup is clicked.
Modeling Machine Tab
Display Function
Command Set
Select the appropriate command mode to match the software to be used.
•
[RML-1] : Select this command set when you want to use the software that was included with this machine
• [NC Code]
: Select this command set when you want to use NC codes
"
"NC Code Specifications" (p. 111)
•
[RML-1/NC Code] : Select this option to enable the machine to receive cutting programs that use the RML-1 or NC code command sets
"
"STEP 3 : Confirm the Command Set"
(p. 83)
Initial setting :
”RML-1”
Power Option
The machine's power can be automatically turned off (auto-power-off function). You can disable auto power-off or enable it so that the
power is automatically turned off in 0.5 to 24 hours.
Initial setting :
"0.5 hours"
Unit
The display of the unit of a coordinate system can be chosen. ( For the inches display, the millimeters value is converted and displayed.)
Initial setting :
“Millimeters”
Direction of Y axis using
keypad
The movement direction when the Y-axis feed button is pressed can be set. Under the factory default settings, Y-axis movement assumes a
direction of cutting tool movement relative to the object being cut. This means that clicking a Y-axis feed button makes the table move in
the opposite direction from what the arrow indicates.
Initial setting :
”Move cutting tool to desired location”