9
Making the Connections
Switching the Power On and
Off
Once the connections have been completed, turn on power to
your various devices in the order specified. By turning on
devices in the wrong order, you risk causing malfunction
and/or damage to speakers and other devices.
1.
Make sure that all volume controls on the KC-60 and
connected devices are set to 0.
2.
Turn on all the devices connected to the KC-60’s input
jacks (CH 1 through CH 3 and AUX IN).
3.
Turn on the KC-60.
4.
Switch on any equipment connected to the KC-60’s LINE
OUT or SUBWOOFER OUT jacks.
5.
Adjust the volume levels for the devices.
6.
Before switching off the power, lower the volume on
each of the devices in your system and then TURN OFF
the devices in the reverse order to which they were
switched on.
* This unit is equipped with a protection circuit. A brief interval
(a few seconds) after power up is required before the unit will
operate normally. For protection from sudden big sound, always
make sure to have the volume level turned down before
switching on power. Even with the volume all the way down,
you may still hear some sound when the power is switched on,
but this is normal, and does not indicate a malfunction.
About the Volume-level
Settings
In order to get optimum sound from the KC-60 when
performing, set the volume as described below.
1.
Operate the CH 1 through CH 3 volume knobs to adjust
the volume level for channels 1 through 3.
fig.11
Adjust the volume balance for channels 1 through 3 at this
time.
* To adjust the volume level of equipment connected to the AUX
IN jacks, use the controls on such equipment.
2.
Adjust the LOW and HIGH knobs to obtain the tone you
want.
3.
Use the VOLUME knob to adjust the overall volume
level.
fig.12
* If the sound is distorted, lower the CH 1 through CH 3 volume
knobs, VOLUME knob and/or the volume knobs for devices
connected to the input jacks (CH 1 through CH 3 and AUX IN).
