15
HP-555G
Nov. 1998
STAND ASSEMBLY (KS-505)
1. Part Check
Before you begin assembling the stand, check that all the parts
were supplied. You will also need to have a Phillips
screwdriver.
A :
Side Board ( left )
B :
Side Board ( right )
C :
Pedal Board
D :
Rear Board
Screw a ( 4 x 20 mm ) x 8
Screw b ( 4 x 25 mm ) x 4
Screw c ( M5 x 20 mm ) x 2
CAUTION
•
Make sure that another person is on hand to help with the
assembly and setup.
•
When assembling the piano stand, do not apply excessive
pressure on any part. To do so can cause metal parts to get
bent out of shape, and may damage wooden parts.
•
Be very careful, when you assemble and move the piano,
to make sure that you do not drop it on your hands or feet.
•
To move the piano, lift it carefully—all the while keeping
it level.
•
Fasten each screw tightly, then place the stand in a stable
and horizontal place.
•
Do not allow the pedal cord or power cable to get twisted
or pinched while assembling the stand.
•
At first, assemble the entire stand in a temporary fashion,
without really tightening the screws. Then, after checking
the overall alignment of the boards (and gently shifting
certain parts where necessary), go around and tightly
fasten each of the screws.
2. Fixing the Pedal Board and Side Boards
¡
Position the Pedal Board so it rests on top of the metal
fitting at the bottom of the Side Board
q
.
¡
Move the Pedal Board so it is in close contact with the
Side Board
w
, then while shifting it forward or backward
as necessary
e
, push it down until it has been grasped
firmly by the metal fitting
r
.
¡
Push the Pedal Board in the direction of the arrow
t
,
then fasten it with screws “a”
y
.
¡
In the same manner, fasten the other side with screws “a”
u
.
C
D
A
B
Screw a
Screw a
Pedal Cord
